Child weight limit 22 lb (10 kg) when using the adapter.
Maxi-Cosi CabrioFix: back panel must be unclipped or removed; Maxi-Cosi Citi and Pebble: strap will be tight.
The seat strap must be buckled over the car seat, and all clips must be fully closed.
About this pair
The UPPAbaby Mesa (original) goes on the Thule Urban Glide 2 with the Thule Urban Glide 1 & 2 universal car seat adapter. With the carrier on, you are pushing about 34.9 lb (25 lb stroller, 9.9 lb carrier).
Read more ↓Show less ↑
7 other infant seats fit the Thule Urban Glide 2.
The answer is not the same on every Urban Glide: it differs on the Urban Glide 3, as the table below shows.
Summary from the makers' published data.
How to set up the UPPAbaby Mesa (original) on the Thule Urban Glide 2
What you need
The Thule Urban Glide 2
The UPPAbaby Mesa (original) carrier
The Thule Urban Glide 1 & 2 universal car seat adapter
Step by step
1Set the stroller's parking brake and open the clips on the adapter.
2Fit the adapter on the left side of the stroller (as you face it): open the velcro and zipper on the center seat divider and clip the adapter to the accessory mount there, keeping fabric out from under it.
3Clip the other end onto the stud on the left side frame, close the velcro, and give the adapter a sharp pull to check it is secure.
4Unfold the adapter and set the car seat in it facing the handlebar, at the angle its maker requires.
5Buckle the seat strap over the car seat and pull it tight.
6Lift gently on the car seat handle to check it is attached.
Thule says it needs an adapter (Urban Glide 1 & 2 universal car seat adapter), without saying which version.
“Car Seat Compatibility - Thule Glide and Thule Urban Glide 1 & 2 | BRAND MODEL | UPPAbaby | Mesa ... WARNING! Maximum child weight must not exceed 10kg (22lbs) when using these car seats with the Car Seat Adapter.”
