This answer is for the BOB Revolution Flex 3.0, though one maker didn't say which version.
Key specs
Adapter
about $99.99
Weight with carrier
38.4 lb
Stroller folded
38 x 25 x 16 in (L x W x H, wheels on)
Good to know before you click it on
The 2 removable receivers are needed only on Alterrain / Alterrain Pro.
Never jog with an infant car seat attached; the store page lists 'From Birth with Infant Car Seat (walk only)'.
About this pair
The UPPAbaby Mesa (original) goes on the BOB Revolution Flex 3.0 with the BOB Jogging stroller adapter for UPPAbaby seats (model S12046600), about $99.99. With the carrier on, you are pushing about 38.4 lb (28.5 lb stroller, 9.9 lb carrier).
Read more ↓Show less ↑
14 other infant seats fit the BOB Revolution Flex 3.0.
Summary from the makers' published data.
How to set up the UPPAbaby Mesa (original) on the BOB Revolution Flex 3.0
What you need
The BOB Revolution Flex 3.0
The UPPAbaby Mesa (original) carrier
The BOB Jogging stroller adapter for UPPAbaby seats (model S12046600)
Step by step
1Set the parking brake and rotate the canopy toward the handlebar.
2If the stroller has no built-in receivers, push the included R and L receivers onto the yellow pins behind the seat fabric until they click and green bars show.
3Push both end caps of the adapter straight into the receiver sockets until each side clicks, then pull the front tube to check it is locked.
4Recline the stroller seat and set the car seat on the adapter rear-facing and centered, lining up the car seat's carry-handle hinge with the receivers.
5Push the car seat straight down until both sides click.
6Lift up on each side of the car seat to check it is secure.
